JET S20 Silicone Mould Release Spray for Injection Moulding Machines
Silicone Mould Release Spray
: Silicone Polymer
: 0.7 to 1.0 gram / second
: -50 to 400 o C
: 21 TO 23 Sq.cm @ 9 to 10 inches between the nozzle and
Spray cone angle
: 30 to 40 deg
: 3 to 4 microns @ 9 to 10 inches between the nozzle and
:600 ml aerosol can.
‚tã¸’“™ÖÅÊ²ó in carton, containing 25 cans.
Contents are non toxic.
: Non sticky, low surface tension (high film forming capacity), and
excellent flow friction coupled with lubricating qualities of the formulation helps the shop floor
men to increase productivity.
For moulding Polyethylene, Polypropylene,
HIPS,Acrylics, Polyurethanes, Bakelite,
Polyesters, Cellulose, SBR, Natural Rubber,
Nitrile, Neoprene, Fluorosilicone Polymers, etc.
Material safety data : Contents under pressure.Do not expose to higher
temperature or flame.Shall be disposed carefully when the content is emptied. Do not drop the can.